Apex Slide for Hellcat and Hellcat Pro

Description

The Apex Slide for Hellcat and Hellcat Pro is machined from heat-treated stainless steel, built to handle the salt, sand, and humidity of a Florida coastal environment. It’s 100% Made in the USA, right here in Phoenix, AZ, and works with all Apex aftermarket Hellcat slide components and barrels, as well as all factory Hellcat slide parts. This is a partially stripped slide — you’ll need to provide the slide internals, including the barrel, recoil assembly, and your choice of striker, extractor, and back plate components.

Why this slide matters for your EDC: Corrosion resistance is the backbone of this build. The black slide gets a durable Black PVD finish, while FDE slides feature Cera-kote applied over PVD on all visible surfaces. That means fewer rust worries after a day at the beach, a sweaty concealed carry session, or a sudden summer downpour. The heat-treated stainless steel core adds long-term structural integrity, so you can run thousands of rounds without worrying about slide flex or wear.

• Optic Cut: Direct mount for Holosun K Series optics — fits the 407K, 507K, EPS, and EPS Carry. Also fits Shield Arms RMSC optics (use the screws included with the RMSC). Optic mounting holes are 4mm x .7mm with 4+ threads for maximum holding power.
• Key design detail: The optic mount holes do not penetrate into the extractor spring channel. This prevents optic screws from interfering with the extraction system, no matter what screws you use.
• Optic Cover Plate: Each slide comes with a 3-pack of 3D printed Optic Cover Plates (black, red, and blue) plus a set of OCP screws. Designed to match the slide’s profile exactly.
• Sights & Co-witness: XS Tritium Night Sights are pre-installed. Front sight features an orange ring with a green tritium dot. Rear sight has two green tritium dots. These sights co-witness through the Holosun 407/507K optics in the lower 20% of the window — perfect for low-light or no-light shooting without losing your dot.

Fitment notes: The slide works with all factory Hellcat/Hellcat Pro slide components and barrels. If you’re swapping from a factory slide, you’ll need to install the striker assembly, striker block and spring, extractor and extractor plunger assembly, slide back plate, barrel, and recoil assembly. All Apex aftermarket Hellcat barrels and components are compatible as