Description
If you carry a CZ P-10 Optics-Ready pistol near the coast, you know that salt air, humidity, and sweat are constant threats to your gear. Standard mounting plates can rust, corrode, or fail when you need them most. That is why this Apex Optic Mount is built from billet steel, machined in Arizona, and designed specifically to survive the Florida environment while keeping your red dot locked tight.
This mount is engineered to fit the CZ P-10 slide that already has the factory Optics-Ready cut. No modification, no gunsmith fitting, no guesswork. You remove the factory cover plate, clean the slide surface, place the mount, and torque the included screws to 15 in-lb. That is it. Your optic sits low and secure, co-witnessing with standard height sights on most setups.
Optic compatibility:
- Aimpoint Acro P-1 and P-2
- Steiner MPS
- Lead & Steel Pandora PB-3
If you run any of these footprints, this is your direct-mount solution. No adapter plates, no stacking tolerances, no extra points of failure.
Why this matters for your daily carry:
- Steel construction — This mount is machined from a solid billet of steel, not cast or sintered. Steel resists corrosion better than aluminum in coastal humidity and holds up to the recoil impulse of your P-10 without cracking or deforming.
- Direct mount to factory slide — You are not adding a plate on top of a plate. The mount interfaces directly with the CZ Optics-Ready cut, keeping your optic as low as possible and reducing the chance of screws backing out.
- Included mounting screws — The package comes with the correct screws for your CZ P-10. No need to chase down the right thread pitch or length. Just clean, torque, and go.
- 15 in-lb torque spec — Apex recommends cleaning the slide before installation and torquing screws to 15 in-lb. This spec is easy to hit with a small torque wrench and prevents over-tightening that can strip threads or crack optic housings.
- Designed for the real world — Whether you are carrying appendix during a summer thunderstorm or running drills at the range in 90% humidity, the steel body and corrosion-resistant finish hold up. This mount does not need babying.
Fitment notes: This mount is for CZ P-10 pistols with
Reviews
There are no reviews yet.